Theoretically various OCA, Acrylates and Silicone can be used for Gel Bonding

Distec has been bonding in the VacuBond® dry gel process for more than 5 years, revolutionizing the optical bonding market. Never before has a zero-optical-error agreement been standard, never before there was a response time for prototypes of one to two weeks.

Distec’s development team invests time and again in test series with different gel materials to ensure that only the best material is used. The test criteria are adhesion power, processability, operating temperature range, yellowing and repair options.

In the past 12 months, we specifically tested the low priced polyacrylate / acrylic materials used by our competitors, and the Taica OPTαGEL is the clear winner of these tests (see picture). In matters of adhesion power, all the materials used were very good, but during processing, the OPTαGEL took  the lead, saving time and money during the bonding process. In three points, however, the Taica Hi-Tech silicone is head and shoulders above the rest:
  1. The OPTαGEL is specified for a very wide temperature range of -40 to +120°C and therefore also covers the temperature range of components that have been developed for extremely rugged applications. The Mitsubishi displays of the AT series, for example, are suitable for an operating temperature range of -40 to + 85°C, which the acrylates with their temperature range of -30 to + 80°C cannot cover completely, in contrast to the OPTαGEL.
  2. Acrylates are prone to medium-term yellowing and thus affect the appearance of the high-quality bonded unit. The OPTαGEL does not yellow and remains clear in the long term.
  3. Once cured, the acrylate-bonded components can no longer be separated without destroying them. If a failure occurs, the entire unit is waste. The VacuBond® Optical Bonding process is reversible and the high-quality components such as display and touch screen can be repaired or replaced individually if required.

Since we only optically bond for industrial applications with high demands on long-term quality, we cannot use the cheaper polyacrylate / acrylic material despite the cost savings for the mentioned reasons.

The approach of using only the high-performance silicone OPTαGEL developed by Taica for optical bonding is confirmed by each additional certification.

Please contact us. We are happy to advise you on our <link internal-link>VacuBond® optical bonding process.